QRFS.com is open and fulfilling orders. Read our Emergency Preparedness Guide.

Viking Head Guard for XT1 Fire Sprinklers | Model XG | 1/2″ & 3/4″ NPT | 22931

SKU
VKXGHG
Only Viking’s Model XG Fire Sprinkler Head Guard can safely protect Model XT1 fire sprinklers against mechanical damage. These steel-wire sprinkler cages fit 1/2″ and 3/4″ NPT XT1 fire sprinklers (upright or pendent), and can be paired with the Viking XWU or F-1 water shields for additional protection.
$5.95
SKU Material Compatible Sprinkler Types
VKXGHG Bright Basic Steel Wire Viking XT1 Pendent & Upright Fire Sprinklers
Viking Part Number Availability
22931 Usually Ships Within 48 Hours

Viking Model XG Head Guard for XT1 Fire Sprinklers

Only Viking’s Model XG Fire Sprinkler Head Guard can safely protect Model XT1 fire sprinklers against mechanical damage. These steel-wire sprinkler cages fit 1/2″ and 3/4″ NPT XT1 fire sprinklers—both upright and pendent.

At 2 15/16" wide and 2 3/16" tall, Viking’s Model XG Sprinkler Guard protects sprinklers while adding less than an inch to overall height. When coupled with the Viking XWU water shield, this head guard can protect intermediate rack-storage models against unwanted spray from nearby sprinklers.

Which sprinklers need a Viking Model XG head guard?

In systems that comply with NFPA 13, any fire sprinkler that’s likely to collide with people, machinery, or other moving objects needs a head guard. However, the Viking Model XG is the only sprinkler cage that doesn’t interfere with the activation of XT1 heads. Nearly all other head guards can pinch the hinged plug of an XT1 fire sprinkler, causing the head to malfunction.

The Viking Model XG Head Guard may be used with sprinklers having the following sprinkler identification numbers:

  • VK1001
  • VK1021
  • VK3001
  • VK3021
  • VK2002
  • VK2022
  • VK3502
  • VK3522
  • VK2001
  • VK2021
  • VK3501
  • VK3521

How is the Model XG head guard installed?

Model XG guards require two tools to install:

  • Viking’s XT1 Sprinkler Guard Wrench
  • A T15 Torx screwdriver

Because these guards fit snugly around XT1 fire sprinkler heads, installation requires special care:

  • First, loosen the Torx screw on the guard.
  • Open the hinged door.
  • Slide the sprinkler into the guard at an appropriate angle. Pendent heads insert upright. Upright heads should be inserted at roughly a 30-degree angle.
  • Rotate the sprinkler 90 degrees or until the plug’s hinge isn’t blocked.
  • Close the guard and tighten the Torx screw.

Dimensions

  • A: 2-15/16″ (75 mm)
  • B: 2-3/16″ (56 mm)
  • C: 3/32″ (2.3 mm)

Documents

Download the data sheet for this Viking XT1 Fire Sprinkler Head Guard

Write Your Own Review
You're reviewing:Viking Head Guard for XT1 Fire Sprinklers | Model XG | 1/2″ & 3/4″ NPT | 22931
Your Rating